No display on injector 1
No display on injector 1
Hi having trouble with the injector iv seen a regen a couple of months ago but very rare. Does this mean I have a fault or is the software reading incorrectly.
Re: No display on injector 1
Your engine is partially supported: the post injections (last 3 fields) don't work and you can disable them (click to grey out) so the app doesn't waste time trying to request those parameters.
But these 3 values aren't important to check the DPF behavior, you have to check the first field with soot mass calculated: this is the value used by the ECU to understand the right moment to start the field regeneration. It should increase using the car until it reaches the predefined limit when the ECU tries to start the regeneration is all other requirements are fulfilled.
But these 3 values aren't important to check the DPF behavior, you have to check the first field with soot mass calculated: this is the value used by the ECU to understand the right moment to start the field regeneration. It should increase using the car until it reaches the predefined limit when the ECU tries to start the regeneration is all other requirements are fulfilled.
Re: No display on injector 1
Thanks for that explanation, The screenshot was 2 days after a emergency regeneration as I have never seen the input temperature ove 280 C, I have seen the DPF go red very briefly, and every couple of months I pull a flashing coil light on the dashboard. I have changed a glow plug recently as vcds flagged that fault. That's why I was worried about the 1st injection as that's what heats it up when soot is high.